12 Dec
12 Dec
11:30 a.m.
It might be difficult to build something equivalent to the AVR Scope Clock
from scratch for less than $30 by the time you're
all done, if this
hardware is suitable for your needs.
http://www.sparkfun.com/products/9306
I don't have one of these myself yet but I should buy one to make use of my
Tek X-Y monitor.
17 Dec
17 Dec
8:01 p.m.
The scopewriter isn?t really a vector display. It generated a sideways ( 90
degree ) raster that scans from bottom to top of the display by virtue of a
ramp voltage. It creates ASCII characters from a character generator ROM
that turns the ramp on and off without using Z axis. It is a kind of return
to zero ( voltage ) display when the modulator (character generator ) says
to turn off the transmission gate ( 4066 ) to blank that section of the
character. Very cool idea for it?s time. Mine is somewhere in storage hell.
Best regards, Steven, KJ6STF
On Mon, Dec 12, 2011 at 11:30 AM, Glen Slick <glen.slick at gmail.com> wrote:
It might be difficult to build something equivalent to
the AVR Scope Clock
from scratch for less than $30 by the time you're all done, if this
hardware is suitable for your needs.
http://www.sparkfun.com/products/9306
I don't have one of these myself yet but I should buy one to make use of my
Tek X-Y monitor.
8:25 p.m.
On Dec 17, 2011 8:05 PM, "alan canning" <scanning.cc at gmail.com> wrote:
The scopewriter isn?t really a vector display. It generated a sideways (
90
degree ) raster that scans from bottom to top of the
display by virtue of
a
ramp voltage. It creates ASCII characters from a
character generator ROM
that turns the ramp on and off without using Z axis. It is a kind of
return
to zero ( voltage ) display when the modulator
(character generator ) says
to turn off the transmission gate ( 4066 ) to blank that section of the
character.
Is that anything similar to the scope display built into the SYM-1 board? I
have looked at that in the manual in the past but have never tried hooking
a SYM-1 up to a scope. Has anyone on the list experimented with that?
3 Jan
3 Jan
11:12 p.m.
On Mon, Dec 12, 2011 at 2:30 PM, Glen Slick <glen.slick at gmail.com> wrote:
It might be difficult to build something equivalent to
the AVR Scope Clock
from scratch for less than $30 by the time you're all done, if this
hardware is suitable for your needs.
http://www.sparkfun.com/products/9306
I don't have one of these myself yet but I should buy one to make use of my
Tek X-Y monitor.
I have an older version of the hardware - binding posts for scope
probes, no on-board amplifier to directly drive scope inputs via BNC
cables, but otherwise similar. I had fun putting it together in 2008.
-ethan
4741
days inactive
4764
days old
4 comments
4 participants
participants (4)
-
ethan.dicks＠gmail.com -
glen.slick＠gmail.com -
rmu_scada＠yahoo.com -
scanning.cc＠gmail.com