22 Oct
2017
22 Oct
'17
10:10 a.m.
On 10/20/2017 6:46 AM, Camiel Vanderhoeven via cctalk wrote:
On 10/19/17, 6:22 PM, "cctalk on behalf of
Douglas Taylor via cctalk"
<cctalk-bounces at classiccmp.org on behalf of cctalk at classiccmp.org> wrote:
Thanks, it did work. I'll just stay away from DU1:.? I forgot about the
reboot required for these changes to take effect.
Is there a potential problem here?
I have an 11/53 microPDP11 with a RQZX1 controller connected to a single
DEC DSP3043 drive (535MB) and a single RX33 floppy.
The autoconfigure setup in the RQZX1 puts the hard disk at DU0 and the
Floppy as DU1. OK. I boot RT11 from the disk, V5.7. Works fine.
I would like to use some of the extra space on the disk by setting up
RT11 disk partitions.
However, one of the partitions is DU1, but that is what the Floppy is
called. How do I stay away from what seems like a conflict?
Doug
SET DU2: UNIT=0,PART=1
SET DU3: UNIT=0,PART=2
...
** reboot **
INIT DU2:
INIT DU3:
...