25 Mar
2006
25 Mar
'06
12:32 a.m.
Anyone have a set of pertec cables laying around they don't want? (or
will sell/trade)
I've decided to fire up my TS05 which has pcb edge connectors and I need
two cables from the PCB edge connectors to the controller headers.
I'm pretty sure these are standard pertec cables (comments welcome).
I've got an TMSCP and TM11 controller, but no cables :-(
-brad
25 Mar
25 Mar
12:52 a.m.
In article <200603250032.k2P0W7eD005770 at mwave.heeltoe.com>,
Brad Parker <brad at heeltoe.com> writes:
Anyone have a set of pertec cables laying around they
don't want? (or
will sell/trade)
Same here. I scrounged up some Pertec compatible controller cards
from this list and was offered a power cable for my
Fujitsu drive, but
the power cable never arrived. So I still need a Fujitsu power
cable
and the pertec interface cables.
Are these cables straightforward enough that they could be made new
from flat ribbon cable and suitable connectors?
--
"The Direct3D Graphics Pipeline"-- code samples, sample chapter, FAQ:
<http://www.xmission.com/~legalize/book/>
Pilgrimage: Utah's annual demoparty
<http://pilgrimage.scene.org>
1:34 a.m.
Richard wrote:
Depends on what you have on each end. E.g., my controller has
a funky D connector on it :-/
But, the data rates are quite low so maybe something like
twisted pair ribbon ("rainbow ribbon"?) would work nicely.
IIRC, all of the odd numbered pins were ground, etc. And,
the lines are driven with, e.g., LS38's. I'd have to dig
out a service manual for anything more specific...
--don
1:53 a.m.
On 3/24/2006 at 5:52 PM Richard wrote:
So I still need a Fujitsu power cable
and the pertec interface cables.
The connector on the power cable is an Amp 206037-2. Mouser's got it in
stock for less than $4; Jameco's got it for $3.
Does anyone have a Pertec ISA tape controller (with software available)
that they'd like to sell?
Cheers,
Chuck
6925
days inactive
6925
days old
3 comments
4 participants
participants (4)
-
brad＠heeltoe.com -
cclist＠sydex.com -
dgy＠DakotaCom.Net -
legalize＠xmission.com