Important fact : A transputer chip has 4 high-speed (for the time) serial links on it. It can boot from one of those links, you don't need to provide a boot ROM in the transputer's address space. Unless you are doing something seriously odd, you will need at least one board with some kind of host interface on it. Typically this board will have a C011 or C012 chip on it, which is a serial chip for transputer links. One side is a normal 8 bit bus interface, the other is the transputer link. Typically, that sort of host board has 1 transputer and some RAM on it too. The standard use (but not required) is to link one of the links of that transputer to the link interface chip, and use the other 3 links to connect to other transputers. A typical such board would be the B004. which is a full-length 8 bit ISA card. There are also VME-based cards (but watch out, there's at least one VME transputer board where the board expects to be the VME master, _it_ controls other board in the VME crate, and is booted over the transputer link). Connecting up transputers is really easy given the databook. Even working with the bare chip is fairly simple. So personally, I'd try tp get a B004 or clone (and there were many), and a few transputers and get soldering... The other possibily is to use TRAMs. TRAM == TRAnsputer Module, and in the simplest case consists of a transputer chip and some memory. Brought off the module are the links, the control pins (reset, etc) and a clock input (5MHz). There were TRAM motherboards, some of which contained a C004 link swtich IC (which lets you connect the transputer links together as yoy linke -- _It_ is controlled by a further transputer link -- and often a host interface. There was certainly an ISA-bus TRAM mothterboard (B008 IIRC). Finding this stuff is not going to be easy now, alas. -tony

My recommendation would be to first contact Robert at: rdoerr at bizserve.com He has the largest collection ( I know about ) of Hero Jr. parts, panels , manuals, cartridges, ROMs, etc. It would save you $$$$ in shipping to have it all shipped at once. If this doesn't work out, contact me back and I'll get you the panel and mounting studs you need. We can do this offline so we don't bore these good folks here ... Best regards, Steven C. ( adopted parent of many orphaned Hero robots... ) ----- Original Message ----- From: "Keys" <jrkeys at concentric.net> To: "General Discussion: On-Topic and Off-Topic Posts" <cctalk at classiccmp.org> Sent: Thursday, September 22, 2005 6:07 AM Subject: Re: Hero-Jr Parts Needed