Probably preaching to the choir, but if you are going to be mounting an old tape, there are some issues to be aware of. Tape is really stable over time and your data is likely still there. As tapes age, the surface of the gluey oxide coating degrades. The symptoms will be very discernable with a nine-track drive as you can see the head/tape interface easily. The surface of the tape in contact with the drive's head will ablate, leaving gunk on the head. The tape will make a squeaking noise while running and may eventually stop moving due to sticktion at the head. Cleaning the head from time to time may get you through a read of a tape for backup purposes, but there is a machine called a 'tape cleaner' which is a drive which leads the tape through a path seeded with knife-edges. As the tape travels through the machine, the knife edges scrape a layer of oxide coating from the tape and smooths and polishes the surface exposed. This will restore a tape to full usability and should not affect data stored on the tape. Pinch rollers can also collect oxide and need cleaning. Pinch rollers on old drives may be so degraded as to make the drive unusable. I had a Data General cart drive using Qic 300? tapes. The drive roller was wrecked. I found in my junkpile a roller from an Epson Actionprinter 3250, removed it from the printer's output roller and after cleaning the drive axle in the qic drive, used some windex to lubricate a ballpoint pen barrel, stretched the roller onto the pen body, held the body to the face of the drive axel and pushed the roller on. It worked beautifully from then on. Stone knives and bearskins. You can carefully make a set of knife edges on a board, thread the tape through the edges, and use the drive you have to move the tape through your homemade cleaner. Best, Jeff