23 Feb
2008
23 Feb
'08
11:15 a.m.
Q-bus (BA 23, BA123 & (with mods to the mounting hardware) BA213) SCSI
controllers.
What works (in particular with disks + MSCP + VMS), how well and what's
still about ?
What I know is:
CMD CDQ-220/TM supports disks and tapes, and works with RZ2x disks /
MSCP / VMS
DEC KZQSA-AA (aka M5976-AA) is the BA23 Q-bus SCSI controller
CMD CDQ-223/TM is a 220 with EMC shielding for a BA213 box
What I'm curious to know is:
- What boards were made and which are commonly available
e.g. DEC KZQSA, CMD CDQ-220, Dilog SQ706 ?, Emulex UC02 ?, Andromeda
SCDC-11 ?, ...
- The relative (to SCSI 1) performance of each of the boards
- Which boards are "dogs" : gotchas, tape only, unreliability /
electronics failures
And, some specific queries are:
- What is the difference between a CDQ-220/xxx and a CDQ-220A/xxx ?
- What is the functionality of a CDQ-243 (quad board, BA213 cab kit, 2
SCSI connectors) wrt a CDQ-220 / 223 ?
Regards
Martin
23 Feb
23 Feb
12:27 p.m.
At 4:15 PM +0000 2/23/08, Martin Bishop wrote:
What I'm curious to know is:
- What boards were made and which are commonly available
e.g. DEC KZQSA, CMD CDQ-220, Dilog SQ706 ?, Emulex UC02 ?, Andromeda
SCDC-11 ?, ...
- The relative (to SCSI 1) performance of each of the boards
- Which boards are "dogs" : gotchas, tape only, unreliability /
electronics failures
The Viking QDT (disk/tape also available as tape or disk only) aren't
the fastest boards out there (I think those are the CMD boards), but
they're good rock solid boards. With the most recent versions of
firmware they should work good with a CD-ROM. While I use mine in
PDP-11's, I'm thinking about putting one in a MicroVAX III (I want to
move off RA72's and RA73's). I typically have Seagate 2GB
Barracuda's, a Plextor 8x CD-ROM, and either a TZ30 or TLZ06 (4mm)
attached. I've also used a 2x DEC CD-ROM, and IBM 100Mb and 200MB
SCSI drives in the past.
Zane
--
| Zane H. Healy | UNIX Systems Administrator |
| healyzh at aracnet.com (primary) | OpenVMS Enthusiast |
| MONK::HEALYZH (DECnet) | Classic Computer Collector |
+----------------------------------+----------------------------+
| Empire of the Petal Throne and Traveller Role Playing, |
| PDP-10 Emulation and Zane's Computer Museum. |
| http://www.aracnet.com/~healyzh/ |
24 Feb
24 Feb
7:53 a.m.
Zane H. Healy wrote:
At 4:15 PM +0000 2/23/08, Martin Bishop wrote:
Jerome Fine replies:
I have never found a CDROM that was usable - never tried that hard.
I have had good experience for disk drives with the CQD-220/TM
and a friend of mine with the UC07 (if I remember the number - I
don't think it was the UC02, but I could be wrong).
The Dilog SQ706A did not work, but that was 15 years ago when
it was brand new and there was a firmware bug - which Dilog
knew about, but would not fix promptly enough to use. Actually
the CQD220/TM had the same firmware problem, but I had a fixed
working EPROM with the revised firmware in 2 weeks! In both
cases, the bug was a buffer which overlapped a 256 KByte boundary
in physical memory on the Qbus. Since my test program used
6 * 24 KByte buffers, there was a high probability that one
buffer would overlap a 256 KByte boundary.
Sincerely yours,
Jerome Fine
--
If you attempted to send a reply and the original e-mail
address has been discontinued due a high volume of junk
e-mail, then the semi-permanent e-mail address can be
obtained by replacing the four characters preceding the
'at' with the four digits of the current year.
What I'm curious to know is:
- What boards were made and which are commonly available
e.g. DEC KZQSA, CMD CDQ-220, Dilog SQ706 ?, Emulex UC02 ?, Andromeda
SCDC-11 ?, ...
- The relative (to SCSI 1) performance of each of the boards
- Which boards are "dogs" : gotchas, tape only, unreliability /
electronics failures
The Viking QDT (disk/tape also available as tape or disk only) aren't
the fastest boards out there (I think those are the CMD boards), but
they're good rock solid boards. With the most recent versions of
firmware they should work good with a CD-ROM. While I use mine in
PDP-11's, I'm thinking about putting one in a MicroVAX III (I want to
move off RA72's and RA73's). I typically have Seagate 2GB
Barracuda's, a Plextor 8x CD-ROM, and either a TZ30 or TLZ06 (4mm)
attached. I've also used a 2x DEC CD-ROM, and IBM 100Mb and 200MB
SCSI drives in the past.
5988
days inactive
5989
days old
2 comments
3 participants
participants (3)
-
healyzh＠aracnet.com -
jhfinedp3k＠compsys.to -
mjd.bishop＠emeritus-solutions.com