29 Jan
2007
29 Jan
'07
2:52 p.m.
I've observed that Pertec-to-SCSI adapters are
even harder to find
than PC interface cards. The PC cards come up about every 2-3 months
on eBay, but mostly without drivers. I think I've seen exactly one
SCSI-Pertec protocol converter in the last year--and the minimum bid
was about $200.
Here's a little secret, since I probably have enough of them now.
Every Qualstar 1054 has a pertec-scsi bridge board in it. Early ones
used NCR, later ones have their own design.
The last couple of 1054's I've picked up on eBay were MUCH less than $200.
10:49 p.m.
From: "Al Kossow" <aek at bitsavers.org>
The same is true for the 34xx series. This is a Qualstar-developped board,
so there might be some mounting problems etc. Would it be relevant to put
the data/documentation on bitsavers?
Nico
I've
observed that Pertec-to-SCSI adapters are even harder to find
than PC interface cards. The PC cards come up about every 2-3 months
on eBay, but mostly without drivers. I think I've seen exactly one
SCSI-Pertec protocol converter in the last year--and the minimum bid
was about $200.
Here's a little secret, since I probably have enough of them now.
Every Qualstar 1054 has a pertec-scsi bridge board in it. Early ones
used NCR, later ones have their own design.
30 Jan
30 Jan
6:21 a.m.
In article <001401c7443a$bd335b80$2101a8c0 at finans>,
"Nico de Jong" <nico at farumdata.dk> writes:
If you have documentation on them, then yes, please contribute it to
bitsavers!
Al was just recently asking for this...
--
"The Direct3D Graphics Pipeline" -- DirectX 9 draft available for download
<http://www.xmission.com/~legalize/book/download/index.html>
Legalize Adulthood! <http://blogs.xmission.com/legalize/>
From: "Al Kossow" <aek at
bitsavers.org>
Every Qualstar
1054 has a pertec-scsi bridge board in it. Early ones
used NCR, later ones have their own design.
The same is true for the 34xx series. This is a Qualstar-developped board,
so there might be some mounting problems etc. Would it be relevant to put
the data/documentation on bitsavers?
7:05 a.m.
In article <001401c7443a$bd335b80$2101a8c0 at finans>,
"Nico de Jong" <nico at farumdata.dk> writes:
board,
From: "Al Kossow" <aek at
bitsavers.org>
> > Every Qualstar 1054 has a pertec-scsi bridge board in it. Early ones
> > used NCR, later ones have their own design.
> >
>
> The same is true for the 34xx series. This is a Qualstar-developped > so there might be some mounting problems etc.
Would it be relevant to
put
the
data/documentation on bitsavers?
If you have documentation on them, then yes, please contribute it to
bitsavers!
6853
days inactive
6854
days old
4 comments
4 participants
participants (4)
-
aek＠bitsavers.org -
cclist＠sydex.com -
legalize＠xmission.com -
nico＠farumdata.dk