On 4/7/06, Richard <legalize at xmission.com> wrote: Just standard RX02 guts, but mounted in a pedestal as opposed to the more common rack-mount side-by-side arrangement. The controller-end of the pedestal RX02s is the normal-for-later-RX02-drives DB25 arrangement like the one used with the MINC-11 (with the same DB25-to-40-pin-Berg transition board stuck under the fake woodgrain countertop at the top of the pedestal). The RX278 controller cable is a DC37 to either one DB25 or a wye-cable to two DB25s (there's room in the pedestal for two complete RX02 units). If you really had to, I suppose it wouldn't be too hard to take a BC08 and run it from the RX02 board in the pedestal out to, say, an RXV11 or RX8E, but I think in practice it's not too hard to wire up a DB25-to-Berg-40 transition board if you can't find an original one. -ethan