Question about HP3000 weight

Johannes Thelen - and others... HP-3000 Series II? series II?? We would pay handsomely for one. We found our backup archive set of HP-3000 software - heh heh all kinds of software including FORUM/3000 which was a multi user 100 seperate boards bulletin board, electronic mail, electronic poll and voting system, multi user chat rooms... ( this was all pre Internet so it was way cool back then! just gotta read the tapes.... amazed... this grouping of tapes was an off site storage I had forgotten about and re found in the back closet at the house... had not seen it in over 23 years.. I am really hot on getting e series II or II back to have one at the SMECC museum here in Arizona as it was one of my favorite machines but also we have the giant plug in front panel for it that shows all registers that the customer engineer would bring out in a suit case to really get down and dirty.... We have the series II and III interface board as well as the HP-3000 CX series interface board which is a separate item.. see http://www.smecc.org/hp/hewlet16_series_3_with_maint_panel.gif to see it hooked to HP 3000 WACC-B from U Wisconsin Used by Marlys Nelson - HP-3000 Programmer Extraordinaire! this photo was shot after we even had retired the system was using a series 48 with 303 meg drives I kept in next to my desk and would test boards in it.... When the panel was active on the III with users on it it was fun to throw it into single step BEWRAHHAHHAHH!!!AA!!! Ed Sharpe Archvisit for SMECC In a message dated 5/18/2015 2:30:24 P.M. US Mountain Standard Time, aek at bitsavers.org writes: On 5/18/15 1:13 PM, Johannes Thelen wrote: Finding software for the Series II and III has been extremely difficult so please try to find any that was associated with the machine.