18 Aug
2008
18 Aug
'08
5:26 p.m.
On 18 Aug 2008 at 16:45, Eric Smith wrote:
I don't understand where the problem is. The ID
of the tubing has to be
at least 36 mils to fit a 25 mil square WW tail. The smallest I had on
hand was 1/8" OD, and that fit just fine over the pins. 3/32" OD tubing
might work.
To push the pin far enough out, the "pusher" is going to have to
project a certain distance into the hole in the board. Simply
pushing the slight projection of the collar so it's flush with the
wiring side surface of the board simply isn't sufficient to get the
pin out. I can take photos if you're curious. A wire wrap gun bit
(only, not the sleeve) is in the 1/8" OD range and it's way too big.
Thanks,
Chuck