17 Oct
2020
17 Oct
'20
3:06 a.m.
I think they were made by Data Translation.
On Fri, Oct 16, 2020 at 8:00 PM Jerry Weiss via cctech <
cctech at classiccmp.org> wrote:
On 10/16/20 5:34 PM, Mark Matlock via cctech wrote:
I recently acquired an ADV11-D Qbus A/D board
and having been
working on a RSX11M+ driver for it. It is similar enough to the
ADV11-C
that the driver I wrote for the -C works ok, but the -D is DMA capable.
It seems to have two extra CSR registers in addition to the CSR,
and read
buffer. Does anyone have documentation for this board? It is
mentioned in the Oct. 88 Microsystems Option Guide and both RSX and VMS
supported it. It was also mentioned in the Dec 92 Real Time Products
Technical manual.
It has a 40 pin IDC connector that appears to have some amount of
differences
from the ADV11-C and no where have I seen any info on the DMA
capability.
Does anyone have a ADV11-D user manual or XXDP source code for
testing it?
Thanks,
Mark
I just picked a AAV11-D D/A Board for which documentation is also
scarce. The general design may be similar. I should be able to reverse
engineer the analog/digital output section for pin-outs. Lacking
manuals/source code, if someone has an existing driver or software in
binary, I would be willing to disassemble that for its secrets. Perhaps
these boards mimic the methods used by ADAC or Data Translation used for
their Qbus products. Their documentation may also give some insight on
how to setup these CSR's.
Regards,
Jerry