5 Jun
2014
5 Jun
'14
8:13 p.m.
Il giorno mar, 03/06/2014 alle 07.31 -0400, Bob Ammerman ha scritto:
Yep. I think you are right. I had the B and device
code switched.
-- Bob Ammerman
RAm Systems
-----Original Message-----
From: cctech-bounces at classiccmp.org [mailto:cctech-bounces at classiccmp.org]
On Behalf Of Erik Baigar
Sent: Tuesday, June 03, 2014 3:44 AM
To: General Discussion: On-Topic and Off-Topic Posts
Cc: 'General Discussion: On-Topic Posts Only'
Subject: RE: Data General desktop info
Hi,
I think if this is similar to the Rolm's virtual consoles, the correct
syntax would be to enter the device address followed by "B" for boot. i.e.
"33B" would do a channel boot from the floppy drive (Miltope type).
Ehm...
nB sets breakpoints (max 8)
B alone displays the breakpoints...
The right command should be
nL
Load from device
But I don't know the correct device number.
I tried some codes found in internet (but infos are really poor),
with no activity on the floppy drive or on the hard disk.