Review of Philipp Hachtmann's "Omnibus to USB!" board - Update

I received my "Omnibus to USB" board for my PDP-8/E a while back, but a heavy work load prevented me from trying it out until the last couple of days. Review of the "Omnibus to USB" board by Philipp Hachtmann: ---------------------------------------------------------- What it is: A KL8E compatible board which runs at a "blinding" transfer speed. Currently, it's primary use is to dump and restore RK05 packs on a PDP-8/E/F/M to/from a PC. Speed: Transferring an entire RK05 pack to a PC takes less than 51 seconds. With verify it takes 1 minute and 40 seconds. Restoring a pack of time as dumping. Will it work O.K. on a "loaded" system?: In short, the answer is "yes". Here's the configuration of my test PDP-8/E: (1) KK8-E CPU (1) KE8-E Extended arithmetic element (1) KM8-E Memory extension and timeshare (4) 8KW DEC Memory - total 32KW (1) RK05 Disk Drive (1) VC8/E X/Y -> VT01 (1) RX8-E Interface -> RX02 (1) MI8-EP Hardware bootstrap loader for RX01/RX02 (1) KL8E Async (1) DK8-EC Crystal Real Time Clock (1) Omnibus to USB This system is at the max in terms of current draw for the H724 power supply. How difficult is it to use? It's very easy to use. It comes pre-configured to use I/O addresses 40 and 41. (Switch changeable). All the software below is downloadable To dump an RK05 pack here's the procedure: Load the SPEED8.RIM program into the PDP-8/E using the standard RIM loader. (Or use SPEED8.BIN via the standard OS/8 loader). Halt the system and set the switch register to 200. Clear/Load/Run On a PC running Linux, run "rktool" as follows: To dump an RK05 disk with verify: rktool -r -V filename To restore and RK05 disk with verify: rktool -w -V filename You can dump/restore as many packs as you like as long as you leave SPEED8 running in your 8/E/F/M. Is there anything to watch out for? 1) It's important to set your Linux USB port properly with the following: "stty -F /dev/ttyUSBx raw -echo" 2) [Change from previous email] There was a minor glitch in the original version of rktools. If you don't ask for a verify, you will get a large weird number of verify errors indicated at the completion of the read or write job. This is a false indication - the image is perfect. I found that a single variable was not initialized - so I updated "rktool" and now it works as expected. (I just sent the updated rktool to Philipp). Regards, Lyle -- Bickley Consulting West Inc. http://bickleywest.com "Black holes are where God is dividing by zero"