30 May
2006
30 May
'06
5:44 p.m.
Hi,
Glen Slick said:
On 5/30/06, Stan Barr <stanb at dial.pipex.com>
wrote:
Good question, to answer that I'd have to read the manual! (Which is on
the Mac not this box...) Most manuals for the 11/73 are online at one of
the usual sources, google should find 'em.
--
Cheers,
Stan Barr stanb at dial.pipex.com
The future was never like this!
Switch 1 enables the LTC to function under software control, switching
it off disables the LTC function. Switch 2 isn't used.
Mine has a 4-way connector which are the 12V and 5V test points - 12V
nearest the switch.
Ok, that matches what I found through trial and error and that's good
to verify that's the way it is supposed to be. Would this normally be
set to disable the BEVENT L signal from the power supply only if
something else in the system was supplying that signal?