14 Sep
2015
14 Sep
'15
5:50 a.m.
I have fiche for ZKDJB0, and fortunately it seems to match at this
particular error and address.
"This test looks for BEVENT to Interrupt when BIT 6 in the BEVENT
Control register is set and interrupt priority level is set to 5".
The particular error that you identify occurs as the result of an EMT
trap anywhere during the test. However, the most likely error would be
that the BEVENT interrupt did not occur. It would seem that the most
likely cause is that you have not configured the LTC clock interrupt -
but I am on my way out the door so I don't have time to look at the
KDJ11 manual to confirm this.
You can bypass this test by setting bit 10 of the XXDP switch register
to 1. This is something you don in XXDP *before* you start the test
program (before you enter the "R" command).
JRJ
On 9/14/2015 4:40 AM, Holm Tiffe wrote:
While checking my repaired KDJ11-A M8192 Board with
xxdp I get
the following error:
BOOTING UP XXDP-XM EXTENDED MONITOR
XXDP-XM EXTENDED MONITOR - XXDP V2.5
REVISION: F0
BOOTED FROM DL3
124KW OF MEMORY
NON-UNIBUS SYSTEM
RESTART ADDRESS: 152000
TYPE "H" FOR HELP !
.R ZKDJB2.BIC
ZKDJB2.BIC
ERROR WHILE TESTING BOARD FUNCTIONS
ERROR # =001166
ERROR PC =040662
043632
@
The Board is working flawlessly otherwise.
Can please someone with such a CPU can do a similar test and what does this
error mean? I get this error with two different J11 Chips.
In the Docs
(
http://bitsavers.trailing-edge.com/pdf/dec/pdp11/xxdp/PDP11_DiagnosticHandb…)
is shown thatthe test should ask for a Switch Register setting, in my case
it doesn't. Is the test defective?
Regards,
Holm