30 May
2006
30 May
'06
2:44 p.m.
On 5/30/06, Stan Barr <stanb at dial.pipex.com> wrote:
Switch 1 enables the LTC to function under software control, switching
it off disables the LTC function. Switch 2 isn't used.
Mine has a 4-way connector which are the 12V and 5V test points - 12V
nearest the switch.
Ok, that matches what I found through trial and error and that's good
to verify that's the way it is supposed to be. Would this normally be
set to disable the BEVENT L signal from the power supply only if
something else in the system was supplying that signal?
Thanks