29 May
2016
29 May
'16
1:48 a.m.
-----Original Message-----
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Brent
Hilpert
Sent: 29 May 2016 02:50
To: General Discussion: On-Topic and Off-Topic Posts
<cctalk at
classiccmp.org>
Subject: Re: Monster 6502
On 2016-May-28, at 6:22 PM, drlegendre . wrote:
the
Could someone also clarify what is meant by "gates" in this sense? Are
we talking about the gates (G) of a FET, as in Gate, Drain and Source
- or are we referring to the composite logic gates (NAND, etc.), built
up of multiple bipolar - or MOS - transistors?
Yes, they're talking FET gates, the internal registers would operate under same basic principle as DRAM does.
Other early microprocs used dynamic registers, I forget which, perhaps
others
can list them.
Far from the first time a processor had dynamic registers.
I've been told that the IBM 709 used inductive (rather than capacitive)
storage
for the main registers.
Many early computers used "Dynamic" store for their registers. Certainly the
Manchester Baby and Mk1 computers used Williams Tubes which need continual
refresh. Not sure about the IBM 701 which used also used Williams Tubes for
Main Store. Many early computers used either Williams Tubes or Delay Line
type store, even for main registers. Pegasus was built like this....
Dave