31 Oct
2007
31 Oct
'07
3:26 p.m.
well, but I have both, if I need 'em. My
"stuff" in terms of nut drive=
rs,=20
sockets and deep sockets in 1/4" drive, and also small combination wrenc=
hes=20
goes all the way down to 1/8" and 4mm. :-)
I know I go a lot smaller than that in open-ended spanners. And yes, I
haev needed them, althoguh not really for classic computer work.
You do need a 1/8" nutdriver to undo the screws holding the end cap on
the motor in an HP9100/9810/9820 card reader. And a similar-size
open-ended spanner to get out the remaining screw holding the brushgear
mounint in place if you want to inspect the armature. The spindle
prevents you using a nutdriver for that last screw.
-tony