31 Aug
2015
31 Aug
'15
6:47 p.m.
On 08/30/2015 05:09 PM, Chuck Guzis wrote:
On 08/30/2015 02:00 PM, Jon Elson wrote:
YIKES! Multilayer! I do have a system for registering
2-layer boards, back when I used to make those myself.
You need a piece of Plexiglas about the same thickness as
the PC board material. You need a scrap of PC board
material to use as a spacer between the front and rear
artwork films. You put this on a light table, and glue the
strip of PC board material to the edge of the film, place
the Plexiglas on the film and place the other film on top of
the Plexiglas. Glue the top film with rubber cement and use
a magnifier to adjust alignment until it is as close as you
can get it, then put a weight on the glued joint and leave
it for a couple hours. When the glue is dry, you can slip a
photoresist-covered board between the two films and expose
in a vacuum frame. The two sides will come out well-aligned.
Jon
I hacked a fiber optic light pen onto a Calcomp
plotter
and made some
artwork directly onto film, and then in 1996 I built a
laser
photoplotter that cranks out 1000x1000 DPI images on
red-sensitive
film at 0.6 inches/minute. It can do up to 20 x 24"
films, but I've
never gone over about one foot square. The trick is, it
has to be
VERY accurate to line up with existing PC boards. I
mostly use it to
make solder paste stencils, now, but originally made it
for PC board
master artwork.
That's pretty impressive, Jon.
I do remember the headaches with registration of early
multi-layer PCBs. Lots of rejects.