I would assume that your 11/10 has the suffix -NC.? There were two
versions, the -NC used -15V four wire memory, and the later -SC used
+20V three-wire memory.
The +20V was provided by a MUD slot (Modified Unibus Device) and there
was usually a big red sticker in it warning to not plug a module in that
was not wired for it.
I believe it was standard in all models after the second version of the
I once tried to fix an 11/34 off-contract that somebody had done exactly
that to- I gave up when I found that the +20V had been routed to some
unobtainable ROMs on the CPU board.
Nigel Johnson, MSc., MIEEE, MCSE VE3ID/G4AJQ/VA3MCU
Amateur Radio, the origin of the open-source concept!
Skype: TILBURY2591nw.johnson at ieee.org
On 2022-01-09 17:04, Chris Zach via cctalk wrote:
I'm working on my pdp11/10 getting it back
together. One problem I
think I have is that the secondary memory (a Plessy 700101-100) may be
shorting the -15 line for some reason. Working on it, but does anyone
have a manual or anything like that for this kind of memory board?
Alternately, what kind of Unibus 16k memory board exists to get a
11/10 from 16kw to 32kw of memory? Apparently I can't use a MM11-B as
it requires +20 and -5, both of which are not provided by the power
supply or sourced on a DD11-B backplane module. The 11/10 has +15,
-15, and +5.
On a related note, where did +20 come from for Unibus and which
systems even supported it? Was it an 11/45,11/70 thing?
(Yes, I could build a regulator to take the 30 volts between +15 and
-15 and create an independent 20 volts. Maybe. Likewise I could
generate -5 from the -15 and a 7815 regulator. Maybe.)