27 Jun
2019
27 Jun
'19
8:10 a.m.
On Thu, 27 Jun 2019, Noel Chiappa wrote:
That's what I have suggested him, but he wanted to test his algorithm on
this project, and all I can say is wow :-)
The "ordinary" way of reading the Executable ROS contents is to put the
machine into single-step mode and press RESTART. This effectively enables
access to the ROS contents via the address and data bus on the backplane.
You then force the upper address bits from outside (it's an open-collector
bus), i.e. in increments of 1024 bytes, and sample the 1024 byte block
From: Liam
Proven
This is *epic*.
Indeed. I was blown away by the complexity of his technique for reading
the digits.
I can't believe there wasn't a much easier technique, though, e.g. using a
logic analyzer and a small program to read through the ROS! from the data bus along with the lowest 10 address
bits. The caveat is
that the display controller will be enabled and permanently
accesses the first
1024 bytes of the memory for the screen display.
I had read the contents of my 5110 Executable ROS modules just like Tom,
but I used normal image post-processing and OCR - all that many years ago
and therefore with a lot of manual work involved ;-) But that was
successful at the end and lead to a functional 5110 emulator.
Christian
Perhaps the challenge of doing it his way entertained him, though, like
George Mallory's famous line about climbing Everest.
Noel