17 May
2021
17 May
'21
12:24 p.m.
Not aware of any, however if there is a C compiler for the Pro 300 series then you could
potentially adapt my user mode router to the Pro 300. In fact, it might be a fun project.
However, it isn't the full DECnet stack, just the router and a little bit of the
Network Management layer. I am trying to repair my real Pro 350, although I am not having
much luck so far.
Regards
Rob
-----Original Message-----
From: cctalk <cctalk-bounces at classiccmp.org> On Behalf Of Bob Smith via
cctalk
Sent: 17 May 2021 19:43
To: General Discussion: On-Topic and Off-Topic Posts
<cctalk at classiccmp.org>
Subject: DECNet for Pro 300 series boxes
My recollection of Decnet for Pro boxes is that the available SW was for an
end node and not a routing or other capability for the
380/350/325 boxes.
While that memory might be incorrect, are there any DecNet packages for
the Pro family available anywhere?
a few hours of searching did not turn up any thing but PDFs about the
software.
thanks in advance for any replies.
bob