RX02 Difficulties

Hi everyone, I originally posted this on VCFed (which was new to me) but the moderation queue has had me waiting for about 3 days, so I thought I'd ask here as well, the usual of gurus. :) I was recently sent an RXV21 controller so I could test out my RX02 drive. When I power up the PDP-11 or reset the machine I get the nice clunking sound which I have been told is normal. I expect I wouldn't hear this if the ribbon cable was in the wrong way. To test, I tried to use VTserver to dump the contents of a disk, but it immediately threw an error. I soon realised there are two DIP switches on the logic board of the RX02 drive which had to be adjusted to work with the RXV21. So, I had some progress. Output of VTserver almost looked promising but then it hangs, as below: ]] Tape record n from device xx is written as xx(0,0,n) ]] Disk drive xx is written as xx(0,0,0) ]] ]] Enter name of input record/device: rx(0,0,0) ]] Enter name of output record/device: vt(0,0,1) ]] ]] Opened copy.out read-write ]] So, following some advice I booted via TU58em into XXDP and ran the diagnostics: ]] DR>STA ]] ]] CHANGE HW (L) ? N ]] ]] CHANGE SW (L) ? N ]] ]] CZRXFB0 SYS FTL ERR 00040 ON UNIT 00 TST 011 SUB 000 PC: 003476 ]] CSR BITS - LGC TST ]] AC LOW FATAL ERROR ]] REG ACTUAL=000000 ]] REG EXPECT=000000 ]] ]] POSSIBLE FAILING "FRU'S": ]] INTERFACE - M8029 ]] ]] UNIT#0 RXCSR=000000 RXESR=000000 CMD=000000 -> ]] ->NO PWR, CABLED BACKWARDS, STRAPPED RX01, PDP-8 ]] DROP UNIT#0 FROM TEST ]] ]] PASS ABRTD THS UNIT ]] CZRXFB0 SYS FTL ERR 00040 ON UNIT 01 TST 011 SUB 000 PC: 003476 ]] CSR BITS - LGC TST ]] AC LOW FATAL ERROR ]] REG ACTUAL=000000 ]] REG EXPECT=000000 ]] ]] POSSIBLE FAILING "FRU'S": ]] INTERFACE - M8029 ]] ]] UNIT#1 RXCSR=000000 RXESR=000000 CMD=000000 -> ]] ->NO PWR, CABLED BACKWARDS, STRAPPED RX01, PDP-8 ]] DROP UNIT#1 FROM TEST ]] ]] PASS ABRTD THS UNIT ]] CZRXFB0 EOP 1 ]] 2 TOTAL ERRS So, the possible errors according to XXDP: - Bad power - I get 25v, 5v and -5v. The motors are spinning, not convinced it is this? - Cable backwards - I don't think I'd be hearing that clunk. - Strapped RX01 - I don't know what this means - PDP8 - eh? If anyone has any suggestions it would be great to hear them. Thanks, Aaron.