27 Apr
2005
27 Apr
'05
4:38 p.m.
nooo.. I do believe those high speed signals wouls need to run on coax for
the length they're designed to run - I think it's ribbon/coax -I'm guessing
fairly expensive stuff. (I gather this from previous SDI discussion ;)
Pinouts help, bit still doesn't tell me it it's a 1:1 to my RA73 drive or
if it needs swapping etc :( it's possible for short distance ~50 ohm ribbon
cable might work a close enough match to 34 pin flippy ribbon cable sets?
might be worth an experment - now to look up pinouts on the RA73 drive ;)
everything's transformer isolated, but I'm not sure about mysterious drive
drive selects..
cheers
h
Adrian Graham" <witchy at binarydinosaurs.co.uk> wrote
Page 43 is the important one since it details the
connector, but AFAIK
it's
not coax, it's a ribbon cable, though I guess the
principle is the same.
You
could get a correct result using chopped up IDE cables
perhaps......
cheers
a