27 Oct
2015
27 Oct
'15
9:59 a.m.
On 10/27/2015 09:33 AM, Jon Elson wrote:
The ultimate way to drill holes in Plexi is with an
end mill. It can
make a slight chipping when it punches through the back, so you
either need a backstop material or lighten up the feed a bit just
before it goes through. (This of course requires a center-cutting
end mill, I prefer 4-flute for this.)
Sure, but I'm assuming that the original poster doesn't have a
Bridgeport mill at his disposal. But a drill press is quite within the
budget of most hobbyists. I'd think that if you already owned a
vertical mill, you'd know how to work with plastics.
Back in the day, I loved hanging out at the model shop just watching the
action and trying to second-guess the guys there. Building a case with
curves such as side contoured to a 200 inch radius was serious business.
The finished product was in clear acrylic, all ready to go to the mold
makers.
Similarly, making the die set for punching sector holes in a 8" floppy
would be child's play for someone with a wire EDM rig in his garage.
But not every hobbyist can afford one.
--Chuck