Microvax II 'primer'?

So, I picked up (and I did just carry it into the house, and now I hurt) a Microvax II from another list member yesterday. Cosmetically it's a disaster (BA123 has a cracked top panel, broken wheels, missing front door, missing right-rear panel) but internally it appears to be complete; board wise we have: M7606 - CPU M7608 - 4MB ram M9047 - grant continuity M7504 - DEQNA ethernet M3104 - DHV11 8-port serial M7555 - RQDX3 disk controller M7546 - TX50 controller ... it's got a TK50 and hard drive (no idea of capacity). Operational status is a complete unknown, and I have absolutely zero knowledge about these systems - so my question at this stage is what background reading I need to be doing in terms of pre-powerup* checks, actually hooking a console, if there's a suggested minimal config I can use to diag the CPU, and then (assuming it gets to that point) how to actually use the thing (I'm assuming it was running VMS rather than Ultrix, but I don't know for sure). I'm wondering there aren't any handy tutorials out there, alongside whatever DEC docs are recommended. * e.g. for most machines I'd be thinking in terms of pulling all boards/drives, hooking up a dummy load to whatever PSU rails required it, and then at least running the PSU up in isolation first, but I don't know to what extent this machine requires some logic in place for the PSU to even run. cheers Jules