13 Nov
2018
13 Nov
'18
11:42 p.m.
It is a mouse systems mouse, model M4Q, and it has the two holes (one red light, one
infrared), so I'll need the blue-and-black grid. I've hopefully bought a correct
one off eBay, just waiting for it to arrive.
Camiel
?On 11/14/18, 3:32 AM, "cctalk on behalf of systems_glitch via cctalk"
<cctalk-bounces at classiccmp.org on behalf of cctalk at classiccmp.org> wrote:
There's a blue-and-black grid, and an all-black grid, at least with Sun
mice. Mice that work on one won't work on the other. At least with the
blue-and-black grid, spacing didn't seem to matter -- I've got three sizes
of spacing, all three work with the mice that support it.
Not sure if it applies to your situation, but the Mouse Systems mice with
two holes, one emitting red light, work with the blue-and-black pads, and
the newer Sun mice with a single hole works on the black grid. The
blue-and-black grid looks metallic blue until you take a close look with a
lighted magnifier.
Thanks,
Jonathan
On Tue, Nov 13, 2018 at 5:40 PM Rico Pajarola via cctalk <
cctalk at classiccmp.org> wrote:
On Tue, Nov 13, 2018 at 10:32 PM Tomasz Rola via
cctalk <
cctalk at classiccmp.org> wrote:
On Sat, Nov 10, 2018 at 07:12:49PM +0100, Camiel
Vanderhoeven via cctech
wrote:
I never tried, but I don't think this would work. AIUI, it has a minimum
and a maximum spacing for the lines.
The white noise sheet "works" because some the black-white-black
transitions come with the right spacing, no matter what that spacing is (it
has to be the right order of magnitude, and it doesn't work as well as the
real thing). Crumpled tin-foil has been reported to work, too.
On 11/10/18, 6:49 PM, "Rico Pajarola"
<rp at servium.ch> wrote:
I have tried to print my own mousepad, but the mouse only works in
the y direction on it.
there were 2 versions of that mousepad, and the symptom of using the
wrong one was that the mouse would only move in one direction.
Out of curiosity, would it work if you printed this one-directional
grid on a translucent plastic and overlaid it on top of white paper
sheet? If yes, then would it work if you printed two such translucent
plastic grids and ovelaid them one on the other turned 90 degrees and
that on white paper?
--
Regards,
Tomasz Rola
--
** A C programmer asked whether computer had Buddha's nature. **
** As the answer, master did "rm -rif" on the programmer's home **
** directory. And then the C programmer became enlightened... **
** **
** Tomasz Rola mailto:tomasz_rola at bigfoot.com **