More PDP-8/L repair fun (bits won't read/write)

Some of my bits not setting turned out to be bad parts on the front panel! 15 years ago I installed LEDs/resistors in place of all the (mostly burned out) incandescent lamps. One had a cracked composition resistor, and the other an open (base-emitter) driver transistor. As I posted earlier, the problem with the core not reading/writing bits 5-11 was indeed the MEM ENABLE signal from the M617 in slot A09. But the 7440 was good for a change (not one of the bad batch with 7005 date code). Turns out the wire from that pin on the backplane was installed too tightly at the factory and had shorted through the insulation to a ground pin. Now the core works, and CPU executes various test programs; SR, AC, MB, MA all working fine... EXCEPT it won't read/write on any of the 128 bytes of page 0! Going to try to figure that one out tonight... Another strange find - the PROTECT key did not, in fact, protect the upper page (7600-7777) of core. I found a factory-appearing wire on the backplane, jumpering the output of an inverter directly to ground! Some idiot probably was bothered by noise giving false PROT errors or couldn't figure out that the switch is off when in the down position, and just shorted the signal out. Now that works, too. Didn't fix the page-0 problem either. The DF and IF switches do nothing (i.e. flipping them does not bomb a running program, or prevent reading/writing from the front panel switches), but I think that's normal without the extra 4K installed. -Charles