< Okay, here's another hair-brained project that I am working on..... < < I am trying to basically build a 64Bit Z-80 on a board. What I am < looking for is: Anyone know of any chips that are EXTREMELY simple < micro-controllers but, work at EXTREMELY high clock rates??? I wanna p < a few on a board with some memory and made a 64-bit Z-80. I'd like th < processor to operate at 300Mcyc (or faster) clock speeds so, I figure I < need micro-controllers that operate at about 900 Mcyc to do the work. < < Any ideas???? Wait till April first for this. I don't think you were listening when we were discussing propagation delays. To deal with 300-900Mhz clock your talking 4-6layer etch and some really fast logic. The .33nS memory will be tough to buy. Be prepared to dump a few DecaKilobucks into the attempt after all you'll need a really fast logic analyser and O'scope to see what you missed. If you want a 32 bit z80 get a z380, it runs native z80 code, until you switch modes then compatability works but it has a lot of gotchas. If your doing a z80 stretch, you better think about how to access memory or really alter the z80 fetch timing. Basic Z80 timing for say 20ns memory would limit you to some 40-50Mhz... it would be a 5-10 MIPS machine though. If you superpipline it and get it down to 1-2 clocks per cycle you can double that. In any case there is no way to logically stretch a z80 without running the risk of making it software incompatable at some point. I've seriously looked at it, still have the 2901s I was thinking of using. I have z80/10mhz parts however and the 2901s would barely do that. FYI: z80S180s can be had into the 30+ mhz range. Allison