On Mon, 23 Feb 2004 TRASH3(a)splab.cas.neu.edu wrote: Joe, would you send me a zip file of the contents of each disk so that I can add it to the archive? Thanks! - don

Hi Joe That sounds right. The full size QIC-36 is right. Most of the jumps are located just above the connector. IRQ 2-7, DRQ 1-3 and DACK 1-3. There is also a 4-pin header (2 x 2) near the crystal (at the back / bottom) called E1 E2 E5 E6. I can copy the discs on some other discs, and then send them to Curt. We can also do it the other way around. I would appreciate your help. thanks Nico You can find my addres on www.farumdata.dk ----- Original Message ----- From: <TRASH3(a)splab.cas.neu.edu> To: <cctalk(a)classiccmp.org> Sent: Monday, February 23, 2004 6:23 PM Subject: RE: Everex EV-831

this is a copy of the backup and restore software. It will help to either use the drive for backups, or read backups created by this program. There are several versions of this, which support progressivly more versions of the hardware. There are the following variants of the hardware. Drive Qic2 interface, 50 pin ribbon, controller, qic2 to qic 24 (or whatever), AT adapter, Qic24 to AT bus Drive Qic 24, Adapter qic 24 to AT bus (this is a full length AT card) there are variants of the second where the controller is 2/3 length, but still AT to qic 24. There is also a series of drives from 60mb, 120mb, 125mb 150mb, which have similar base controller boards, but different firmware. I have not seen 250 and 625 mb in the qic format, but only scsi. the 60, 150, are also available in scsi. You might want to hunt down a drive compatable with your tapes and do scsi, as there are far more tools that will read raw tapes from aspi than from qic 2. Jim TRASH3(a)splab.cas.neu.edu wrote: