Well, today I walked by the auto labs in mech engr and found that they had finally finished dismantling this very old combustion/emissions test rig, and the HP1000 computer that ran the whole show had not been hauled away yet. Somebody had laid a claim on it two weeks ago, but since it's so long already and they haven't showed up, the person who handled the decomissioning gave it to me. I have not been able to open the front panel latch because I do not have the key, so I don't know what's in the front card cage; all I know is that there are seven cards, four at the botton and three at the top. In the back cage there are three jumper cards, two 12821A disk interfaces,one "time base generator card", and four cards marked "BACI 12966A" where most of the control I/O was apparently done. There are two big cards below the main card cage, but I haven't got to them yet. I also got several cables; two of them obviously connected the disk interface cards to an HPIB device (an HP 7946 tape drive also came in the lot), while others went to the test rig, and yet another seemed to go to a PC being used as a terminal. Unfortunately, I don't know where the cables were originally connected, as somebody had already pulled all cables off the computer. The machine is very, very dirty; not surprising considering where it came from (a car shop). The fans are full of oil-impregnated dust. I don't plan to power it up until I know more about it. They tell me that it was still functional about three years ago. Apparently nobody has touched it since. So, does anybody have any info on the power supply of this thing so I can test it before applying power to the cards? And, where did the console go in this machine? Best regards, carlos.