6 Sep
2004
6 Sep
'04
4:25 p.m.
just would like to enquire..
Is the DTI reading for run-out the difference between the high and low limits or is it the
average of the difference
8 Sep
8 Sep
9:14 p.m.
If I recall (been a while since I've seen this thread and I *THINK* I
started it)...
runout would be measured against the outside rim of the platter, thus
checking for a platter that is mounted off-center.
flatness would be measured against the outer top surface of the platter,
thus checking for a platter that is mounted "at an angle".
Jay
----- Original Message -----
From: "Kevin Teoh" <kevintct(a)streamyx.com
To: <cctech(a)classiccmp.org
Sent: Monday, September 06, 2004 4:25 PM
Subject: Runout vs. Flatness and Dial test indicators
just would like to enquire..
Is the DTI reading for run-out the difference between the high and low
limits or is
it the average of the difference
7425
days inactive
7427
days old
1 comments
2 participants
participants (2)
-
jwest＠classiccmp.org -
kevintct＠streamyx.com