Don't know if anybody much cares, but: The HDL synthesis aspect of the SMS data gathering / HDL synthesis application is coming along. I can now handle: - Oscillators (using a counter divider) - Delay lines (using a shift register, so limited to a reasonable number of FPGA clock clock cycles, so, say 200 ns is not unreasonable (20 bit shift register at 100 MHz). - Recognition and consolidation of individual signals into a "bus" when generating groups corresponding to a group of individual ALD sheets. (The individual ALD sheets use the individual signal names as they appear on the sheet). A simple database table associates a given individual signal with a bus, and identifies the bit in the bus that corresponds to the individual signal. So, I have not generated the IBM 1410 main oscillator, its main logic clock and its I Ring - used to control instruction decode. I have synthesized the logic clock into an FPGA and run it (with a slowed down 1410 oscillator so I could see what was going on.) Also, a word about VHDL - and the Xilinx Vivado. While GHDL is useful, I have found that Vivado is not slow at editing and *simulation*. Silly me - I got in the habit of synthesizing stuff before I tested it under simulation - partly because I didn't know any better at first. Vivado's waveform viewer has some advantages (and disadvantages) compared to what is available for GHDL. I have also started exploring a piece of "intellectual property" I can use - MicroBlaze - to allow my generated system to talk to my PC, via TCP, for things like lights and switches. (Kind of like how the Amdahl machines used to use first DG Novas, and later little UNIX systems for their consoles, giving them access to the internals of the machine.) I knew MicroBlaze existed, but now I have actually played with it a bit -- still learning. https://en.wikipedia.org/wiki/MicroBlaze