2 Sep
1999
2 Sep
'99
4:05 p.m.
In a message dated 09/02/1999 7:05:00 PM Eastern Daylight Time,
rigdonj(a)intellistar.net writes:
I've heard that there are knifes available that
can be used in them to
cut strip lines on copper PCB and knifes for cutting out vinyl and other
materials but I don't know what they cost or where you can get them. Does
anyone know any more about them?
Joe
Hmm -- most vinyl cutters are in reality just cheap single-pen plotters with
the equivalent of an Exacto knife in them. Check with wholesale suppliers of
machines for the signage or awards industries and you should be able to turn
up someone who can provide a cutting tool which will come close to -- if not
exactly match -- the holders for your pens.
Or, you can e-mail me off-list & I'll point you in the right direction.
Glen
0/0
3 Sep
3 Sep
4:03 a.m.
At 12:05 AM 9/3/99 EDT, Glen wrote:
In a message dated 09/02/1999 7:05:00 PM Eastern
Daylight Time,
rigdonj(a)intellistar.net writes:
That's about what I expected. But how do they make it cut in different
directions? Or is the knife on a swivel?
Joe
I've heard that there are knifes available
that can be used in them to
cut strip lines on copper PCB and knifes for cutting out vinyl and other
materials but I don't know what they cost or where you can get them. Does
anyone know any more about them?
Joe
Hmm -- most vinyl cutters are in reality just cheap single-pen plotters with
the equivalent of an Exacto knife in them.
9242
days inactive
9243
days old
1 comments
2 participants
participants (2)
-
Glenatacme＠aol.com -
rigdonj＠intellistar.net