An easy one (after that db9 debacle!) - test-drb@ccmp.vtda.org

15 Dec 1999

They can be either 220/330 packs, with Vcc at one end and Vss at the other,
or they can be 150-ohms to Vcc.  If the end opposite the connection to Vcc
is not solidly connected to Vss, then it's the latter.

Dick

-----Original Message-----
From: Chuck McManis &lt;cmcmanis(a)mcmanis.com&gt;
To: Discussion re-collecting of classic computers
&lt;classiccmp(a)u.washington.edu&gt;
Date: Wednesday, December 15, 1999 4:54 PM
Subject: An easy one (after that db9 debacle!)

...
 Ok, so my choice of terms was poor, y'all
understood what I meant :-)

This one should be easy. I've got an ESDI drive, I know that at one time it
had termination resistors in it, I know that I pulled them out, I put them
into my "drawer of misc resistor packs", they are effectively invisible :-)

What is the resistor values for the term pack? 220/330?

--Chuck