Bruce Lane wrote:
1). Confirmation or denial that the address
jumpers on the TQK50 (M7546)
and the TQK70 (M7559) are laid out in the same pattern, bit-wise? In other
words, does each board share the same pattern for setting its address?
Jerome Fine replies:
Hard to say. I am holding both boards in my hands - one in each. The TQK50
uses jumpers and the TQK70 uses dip switches. I NEED better glasses to check
the settings, but I can answer any questions you have if need be.
2). A jumper chart for the TQK70, or jumper
setting info to set it to the
primary tape device address.
I have the TQK70 set at the standard address for the PDP-11 (RT-11). Do
you still need the dip switch values?
Sincerely yours,
Jerome Fine