The use of NiMh's has a 'minor' drawback the internal powerloss is much
larger then when you use NiCad's.
The use of the pack is memory backup for some setup/boot settings.
The uVax runs very well without the batteries the only drawback is you have
to do the setup at every new powerup....
For nowmal operation you do not need the batteries.
Rik
-----Oorspronkelijk bericht-----
Van: cctalk-bounces at
classiccmp.org [mailto:cctalk-bounces at
classiccmp.org]
Namens Tony Duell
Verzonden: vrijdag 6 juni 2008 4:57
Aan: cctalk at
classiccmp.org
Onderwerp: Re: MicroVax batteries
The batteries in my MicroVaxen need to be replaced. A couple of questions:
What's the best way to clean up corrosion damage caused by these
batteries? With Alkaline batteries, I usually use vinegar (since
alkalines leak a base, not acid). What about NI-CD?
The electrolyte in a NiCd cell is also alkaline (potassium hydroxide based,
I think). So you use a (chemically) weak acid for clean-up. I normally used
a solution of citric acid, it smells nicer than vinegar :-)
What types of batteries can these be replaced with? I'm assuming that
this is a NI-CD battery pack. I went to Radio Shack expecting to
simply find a cordless phone battery that I could use to replace it -
the pack appears to be nothing more than three AAA NI-CD cells in series.
Tht sounds very liekly.
Unfortunately, the only sort of phone batteries they
carry are either
too big (AA's) or NIMH. I wouldn't imagine that it would work, but is
it
Do you not have space for the AA size cells? I didn't think MicroVAXen were
that tightly packed...
possible to use NIMH batteries to replace the original
pack? I ended up
buying a small pack at Target, it's a small, three cell (half or third
AA, it appears), phone battery pack. NI-CD, 400mAh. But, you know, I'd
like to know what my options are for the other MicroVaxen...
I've not tried it myself, but I've heard of plenty of people using NiMH
cells is old HP handheld calculators (designed to use NiCd packs) with no
problems, keeping the original trickle-charging circuit. My guess is that
an NiMH pack would be fine in the microVAX too.
-tony