Here is what is available: - two RL01 drives. I grabbed these to save them from the dumpster, but I have no way to try them out. - two PDP-11/03 (BA11) chassis. One is missing a piece of card guide, but it can be stuffed with 11/23 boards and it will run. If you want an 11/23 board set (KDF11-A, 256K RAM, serial/LTC) I'll throw those in too. The card cage is missing from the second BA11, but the power supply, front panel, and fans are there and functional. - a 39 inch high ugly gray 19" rack that will hold the above. - 14 RL01 disk packs. Some are labelled "RT-11 V5 + TSX", "RT-11 archive", and "Fortran". The RL01 stuff was all pulled out of an unheated U-store-it, and I don't know how long it had been there. I don't much about cleaning heads and disk packs, but I would recommend getting some expert advice and checking things carefully before spinning these up. The drives are missing the mounting hardware (slide-out rails, etc.), and the cable from the controller to the first drive. I have a cable to go from the first to the second drive, and the terminator. Free to whoever will come take it away. Located in Chardon, OH, about an hour east of Cleveland. It will *not* be trashed. It doesn't take up much room, so rather than doing a lot of work to pack it for shipment, I'd rather let it sit until someone can come pick it up. -- Jonathan Engdahl http://users.safeaccess.com/engdahl/pdp-11.htm "The things which are seen are temporary, but the things which are not seen are eternal." II Cor. 4:18