On 17 Jul 2007 at 13:26, Scott Quinn wrote:
It is possible to remove these with basic garage
tools: all you need
are a small piece of thin sheet aluminum and a moderate precision 5/64"
metal dowel- in short an aluminum soda pop can and a 5/64 drill. Form
the aluminum into a tube with a slot suitable for 24 ga wire, put
around the pin, pull out- all in less time than it takes to drive to
the semi-local electronics store.
I've had better luck with the local hobby store. Small-diameter
aluminum and brass tubing is available for a slightly more
"professional" version.
Cheers,
Chuck