22 Sep
2020
22 Sep
'20
10:53 a.m.
There is a 1000uf 10v cap on the main logic board just above the Bt display controller.
It is leaking... a lot. (4/4 samples so far)
Go replace it, flush the area and scrub the with 99.9% IPA.
22 Sep
22 Sep
11:03 a.m.
You flush electronics with Indian Pale Ale? Too many TLAs.
This isn't a problem on the model of SparcBook you sold me, is it?
On 9/22/20 10:53 AM, Ian Finder via cctalk wrote:
There is a 1000uf 10v cap on the main logic board just
above the Bt display controller.
It is leaking... a lot. (4/4 samples so far)
Go replace it, flush the area and scrub the with 99.9% IPA.
11:45 a.m.
No, this applies only to Tadpole Series 2 and potentially Series 1 machines (although I
have not observed the latter)
Series 3(/3000) are completely different internally. Your SB3000 is safe- at least from
this failure mode.
On Sep 22, 2020, at 11:02, Alan Perry via cctalk
<cctalk at classiccmp.org> wrote:
?You flush electronics with Indian Pale Ale? Too many TLAs.
This isn't a problem on the model of SparcBook you sold me, is it?
> On 9/22/20 10:53 AM, Ian Finder via cctalk wrote:
> There is a 1000uf 10v cap on the main logic board just above the Bt display
controller.
> It is leaking... a lot. (4/4 samples so far)
> Go replace it, flush the area and scrub the with 99.9% IPA.
24 Sep
24 Sep
8:24 p.m.
Apologies if this is easily found info but is there a good guide on getting
into the tadpole systems? I recall my last time felt futile and I read some
warnings from folks smarter than me suggesting its easy to break but not
properly disassemble.
On Tue, Sep 22, 2020, 1:45 PM null via cctalk <cctalk at classiccmp.org> wrote:
No, this applies only to Tadpole Series 2 and
potentially Series 1
machines (although I have not observed the latter)
Series 3(/3000) are completely different internally. Your SB3000 is safe-
at least from this failure mode.
On Sep 22, 2020, at 11:02, Alan Perry via cctalk
<cctalk at classiccmp.org>
wrote:
?You flush electronics with Indian Pale Ale? Too many TLAs.
This isn't a problem on the model of SparcBook you sold me, is it?
> On 9/22/20 10:53 AM, Ian Finder via cctalk wrote:
> There is a 1000uf 10v cap on the main logic board just above the Bt
display
controller.
> It is leaking... a lot. (4/4 samples so far)
> Go replace it, flush the area and scrub the with 99.9% IPA.
2 Oct
2 Oct
7:58 p.m.
Yea I received a Sparcbook 2 and saw this damage knock some SMD
components off the entire OTHER SIDE of the board from the leaky cap.
Got it going again with cleaning and repair work though.
I had a SB3 fail in its power supply module due to shorted tantrums on
the output side of the supply which cooked the coil and switching driver
chip.
Luckily most of these components were available from digikey at the time
and I rebuilt that entire supply rail and the system came up OK.
-Connor K
On 9/22/2020 14:45, null via cctalk wrote:
No, this applies only to Tadpole Series 2 and
potentially Series 1 machines (although I have not observed the latter)
Series 3(/3000) are completely different internally. Your SB3000 is safe- at least from
this failure mode.
> On Sep 22, 2020, at 11:02, Alan Perry via cctalk <cctalk at classiccmp.org>
wrote:
>
> ?You flush electronics with Indian Pale Ale? Too many TLAs.
>
> This isn't a problem on the model of SparcBook you sold me, is it?
>
>> On 9/22/20 10:53 AM, Ian Finder via cctalk wrote:
>> There is a 1000uf 10v cap on the main logic board just above the Bt display
controller.
>> It is leaking... a lot. (4/4 samples so far)
>> Go replace it, flush the area and scrub the with 99.9% IPA.
1541
days inactive
1552
days old
4 comments
4 participants
participants (4)
-
aperry＠snowmoose.com -
barythrin＠gmail.com -
connork＠connorsdomain.com -
ian.finder＠gmail.com