I've found the Torch XXX hardware docs, which cover that little Trinitron monitor I mentioend It's quite small, probably a 12" CRT. Inside are the following PCBs : FA (PSU), with a control daughterboard. This gives 120V DC from the mains (SMPSU), all other voltages come from the flyback transformer DA (Scan) with a convergence daughterboard. CRT base (icnludes video output stages) BA (Video) H (rear panel controls) Input socket (not Sony, this is a Torch PCB) The input socket PCB connects to the video PCB by a 10 wire jumper. 4 of the wires are grounds, the 6 siganls are R, G, B, Y(== I on a CGA interface), HSynch and Vsync. The Torch socket PCB doesn't connect to the Y signal at all, but then Torch machines had analgue RGB outputs and the BBC micro had 3-bit TTL video, so this would be no problem for the intented applications. Tehre's a 3 position slide swtich on the back to select the input mode. The possiblities are analogue RGB, 3-bit TTL RGB (8 colours) and 4-bit TTL RBGI (CGA compatile, it does get the brown colour right). It's strictly TV-rates only (not EGA or VGA), but it does work with both US and European rates. -tony