On 11/11/19 12:27 AM, Eric Moore via cctech wrote:
Hello, I have a working AED WINC08 drive, which is a
winchester drive
emulated to look like an RL02, along with the qbus controller card.
https://archive.org/details/bitsavers_aedbrochurJan82_2107642/page/n1
The winchester drive itself is a fujitsu M2302B. One of the disks (it shows
up as 2 10MB volumes in RT-11) is having write issues. How can I find a
replacement disk drive in working order? The 2302b has a shugart compatible
interface, so should any shugart compatible 8" winchester drive work in the
aed winc08 rl02 emulator?
What other options do I have to attach a winchester drive to an 11/03 for
use in rt-11? I have an RL02 I have never hooked up, do the disk packs hold
up well over time? How hard is it to clean and align an 8" winchester drive
to try and address the write issue?
Thank you,
-Eric
In my (pre) historic use of products similar to this one, it was rare to swap the vendors
drive with a completely different drive. The controllers, their electrical interfaces and
recording formats were tightly coupled to the disk drives implemented.
My suggestion would be to look for a QBus SCSI Controller like the Emulex UC07 or Dilog
SQ739, though both are a bit pricey. These open up a large number of drives to use and
later versions of RT11 support the MSCP protocol the controllers emulate. The use of the
SCSI2SD drive emulator gives even more flexibility through the use of microSD cards.
Google around for both.
I have an pair of RL02 drives. I keep them clean and power them up for short periods
regularly. You need to be alert to potential issues with electrolytic capacitors drying
out and causing problems in the power supplies and circuit boards of all devices of from
this era. See
http://www.vcfed.org/forum/showthread.php?72247-Dismantle-an-RL02-pack for
a recent discussion and pictures of some of the material in the packs decaying over
time.
Jerry