9 May
2021
9 May
'21
9:12 a.m.
Hi All,
I have two Maxtor XT-4380E drives, one is a Series Code 3 and the other is
4. Is it OK to swap the boards between the two or is this a bad idea? They
physically appear to look the same.
Also a general question about PCB cleanup. Is there a method or solvent of
some sort to clean boards? I've always used 99% alcohol in the past.
-Kurt
9 May
9 May
9:14 a.m.
Sorry, typo... they are XT-8760E drives.
On Sun, May 9, 2021 at 9:12 AM Kurt Nowak <knowak at alumni.calpoly.edu> wrote:
Hi All,
I have two Maxtor XT-4380E drives, one is a Series Code 3 and the other is
4. Is it OK to swap the boards between the two or is this a bad idea? They
physically appear to look the same.
Also a general question about PCB cleanup. Is there a method or solvent of
some sort to clean boards? I've always used 99% alcohol in the past.
-Kurt
3:40 p.m.
Shouldn't be an issue, I got an 8760E working by doing the same kind of
swap (one bad HDA, one bad controller=1 working drive)
C
On 5/9/2021 12:12 PM, Kurt Nowak via cctalk wrote:
Hi All,
I have two Maxtor XT-4380E drives, one is a Series Code 3 and the other is
4. Is it OK to swap the boards between the two or is this a bad idea? They
physically appear to look the same.
Also a general question about PCB cleanup. Is there a method or solvent of
some sort to clean boards? I've always used 99% alcohol in the past.
-Kurt
1328
days inactive
1328
days old
2 comments
2 participants
participants (2)
-
cz＠alembic.crystel.com -
knowak＠alumni.calpoly.edu