I'm 99.9% sure it's a 240. The unit itself is labeled 3590-A50. The FRU on the stand should be 12H0619, I think. Happen to have some in stock? :) Many many thanks! -Ben ________________________________________ From: cctalk-bounces at classiccmp.org [cctalk-bounces at classiccmp.org] on behalf of Doc [doc at vaxen.net] Sent: Thursday, March 21, 2013 8:31 AM To: On-Topic Posts Only Subject: Re: Vertical stand for IBM 7043-43P On 3/20/13 8:39 PM, Benjamin Huntsman wrote: Ben, there were several distinct models of 7043-43P and at least a couple of different stands. Which model is yours? Doc

Hi! Thanks for that link! No, that's not it, so it must be the 140. It looks like this: http://www.frontiercomputercorp.com/Products/Servers/IBM-Servers/RS6000/RS6… There is also a PDF that shows the setup instructions for it here: http://publib.boulder.ibm.com/systems/hardware_docs/pdf/380510.pdf I'm pretty sure it ought to be plastic. The unit I have is pretty compact and isn't very heavy. Many many thanks! -Ben ________________________________________ From: cctalk-bounces at classiccmp.org [cctalk-bounces at classiccmp.org] on behalf of Doc Shipley [doc at vaxen.net] Sent: Thursday, March 21, 2013 3:51 PM To: On-Topic Posts Only Subject: Re: Vertical stand for IBM 7043-43P This guy? http://www.frontiercomputercorp.com/Products/Servers/IBM-Servers/RS6000/RS6… That stand is simply a VERY heavy steel plate with, if I remember correctly, 2 captive #12 screws. The only good one that I have is attached to my 44P. If I didn't chuck it for scrap I might have a damaged one that came with an enterprising soul and a hacksaw could make it right. Or I can certainly get you the measurements to make one. Doc On 3/21/13 12:31 PM, Benjamin Huntsman wrote: