--- jeff.kaneko(a)juno.com wrote: But of course. Depending on the front panel style, if you see two 1/4" holes, one on either edge, it may take an allen wrench. If the panel has no apparent tool access, it's probably held in place by a pair of ball and socket joints on each side which can get extremely tight if pressed on too hard and left to sit. There are times when I think I'm about to bust the balls right off the backplace, and sometimes I'm right. :-( What's inside? What are you offering? At this point, I could even use a new chassis as I have a full set of a mix of verified working and untested boards (128kW MOS, RL8A, etc). I'm sure that the memory and disk I/O work; I am not certain that my spare DKC8AA is any good. ISTR that about 10 years ago I pulled it and set it aside for acting up. I would also like to lay my hands on a programmer's console. It's one of the only things (besides hex-high core) that I'm missing. -ethan _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com