I'm still trying to figure out what's gone wrong with the unibus on my 11/40. To recap -- the machine is responsive if I run it without a terminator at the end of the bus; with a terminator installed the front panel is unresponsive. I've checked the following: - The NPG grants are continuous from the front to the back. - There are grant continuity cards in each empty slot. - I am running with a minimal configuration (only CPU and 64K MOS memory) I made one final discovery about two months ago -- the SPC slot in slot 9 of the main CPU backplane (which I am 100% sure is an SPC slot and not some special-purpose slot) does not work properly. I cannot get the Console SLU/LTC board to function when installed in slot 9 (which is where it's typically installed, or so I hear). It works fine in other unibus slots. I have three questions, any help on these would be, well... helpful. I'm hoping to have some time to play around with it in the coming months. 1) Is the NPG grant on the SPC slot on the processor backplane (slot 9) supposed to be connected to the NPG grants on the Unibus expansion? That is -- right now if I set my DMM to continuity mode and put one probe on CA1 on the first slot of the unibus expansion, and the other on CB1 on the last slot of the unibus expansion, since all NPG grant jumpers are in place, the DMM shows the circuit as closed. This is as I'd expect. However, if I move the probe from CA1 on the first slot of the expansion to CA1 on slot 9 of the processor backplane, the circuit is then open. I'm guessing this is not correct. (There is currently an NPG jumper installed on slot 9.) All other grant lines seem to be continuous. 2) Where is the +15V to the processor backplane supposed to be connected? (I suspect this may be the reason the SLU won't function in slot 9...). Right now it's plugged into pin CV1 on slot 9 (if I'm reading the Unibus pin chart right :)) but the docs I have found say this should be ACLO_L... 3) Does anyone have a wirelist for the 11/40 CPU backplane (or is this in any of the service/reference manuals)? Worst case, I can probe out the wiring and figure out what's missing/incorrect on slot 9. Thanks as always... Josh