Hi everybody, Currently, I'm trying to set up a 11/23 in a BA23 box with a H9278 backplane. Unfortunately, no information can be found on the jumper configuration for the KDF11-A (M8186). The most important question: Does this CPU-Board provide bus termination like the KDJ11 boards ? I plugged in some resistor packs on the dedicated sockets of the H9278 to provide termination, but nothing can be seen on the terminal (9600, 8N1). I'm aware of the QQ/CD configuration for the first 3 slots. The SLU-Card is a SIGMA DLV11-J clone (SDC-DLV11J). Not knowing, which of the 4 SLUs provides the console interface lead me to check out the 4 ports on my terminal, unfortunaltey without any success. The jumper settings on the KDF11-A look like this: top ----------------------------- | | | | | | | These two upper ones are closed | | | __ | | | | | | __1 | | | This is a jumper block of 10 jumpers. The 9th one is open. | | | The other ones are all closed. | | | | --- 10 | | |----| | ----------- ----------- backplane It's a bit strange, that the jumpers do not have any numbers like W1, W2 etc. That's the reason for this drawing. Like the KDF11-A Board, no information on the internet for the SDC-DLV11J either. Jumper W1,W2,W3,W4 are open. There are 6 dip switches. On SW1, jumper 7 is closed, the rest is open, the same for SW2,SW3. SW4: jumper 6 is closed, SW5: 4,7,8 are closed, SW6: 1,5,8 are closed, the rest is open. Can anybody give me any hints on this configuration ? Is the backplane termination required ? Thanks alot in advance ! Regards, Pierre ______________________________________________________________ Verschicken Sie romantische, coole und witzige Bilder per SMS! Jetzt bei WEB.DE FreeMail: http://f.web.de/?mc=021193