-----Oorspronkelijk bericht----- From: william degnan Sent: Wednesday, June 15, 2016 5:35 PM To: cctech Subject: DL11 M7800 OK. I must be missing something here Does anyone have a M7800 (DL11) set for 9600 b N71 or N81 jumper'd with the default address for use as a serial terminal interface? I understand the other jumpers on the card, but the address and vector jumpers confuse me. I can't seem to find a table or a "here is the default for console" or I don't get it. I have the manual, I want I believe 777560, but I cannot find "table 5-2" referred to in my copy of the manual. Can someone give me a couple of examples "if you have Ax Ay Az connected then that represents address ------- . I am looking at the manual and web sites on the subject and I think for use as a simple serial terminal interface I need to jumper "in" *A9, A7, A5, A4, A3* ... correct? Vector jumpers *V6, V7 "*in" . Just curious if anyone can help me specifically not indirectly what I need, super thanks in advance. Thanks Bill --------- Doing this from memory ... I actually configured an M7800 for console a week ago! But I left my notes in the "museum", 9 km away. I could get it on Saturday ... Anyway, I did it using the doc from bitsavers, so it is not too hard: http://bitsavers.informatik.uni-stuttgart.de/pdf/dec/unibus/EK-DL11-TM-003_… The gotcha: for address jumpers a jumper installed makes it a "0", whereas a jumper installed for the vector makes it a "1". I found it pretty confusing, seeing how many scribbled remarks I made on paper :-/ Console address is 777560. The last "0" is A0-A1-A2, and these do not have jumpers. So A5-A4-A3 sets the "6", A8-A7-A6 sets the "5", and A10-A9 sets the low two bits of the "7". (there is no A11). Console vector is 060. Same story. V2-V1-V0 is not available, so you only have to set the "6" (V5-V4 jumpered). To get 9600 Bd, check the crystal. It has to be the frequency listed in the 4th column in the documentation, else 9600 is not selectable. Note that there are two tiny rotary switches on the board. One to set the transmit baudrate, the other the receive baudrate. Testing is easy too. Just LOAD ADDR 777564, then EXAM. If all is correct you will see 0200 (transmit buffer emtpy flag set). Press EXAM again. The "address" is now set to 777566 (transmit buffer). Toggle 073, then DEP. If all is right, you will get a "3" in the terminal. - Henk

Check the cable, if it's not the one you used with the other serial port card. -tony

On Thu, Jun 16, 2016 at 10:58 AM, william degnan <billdegnan at gmail.com> wrote: Does your cable connect E to M? http://www.classiccmp.org/pipermail/cctech/2015-November/012531.html -ethan