11/45 RTC - test-drb@ccmp.vtda.org

28 Mar 2006

I scanned a few xxdp *listings*  and the DL11-W is among them ...
Check http://www.classiccmp.org/bitsavers/pdf/dec/pdp11/xxdp/listings/

there is DL11-E, DL11-W, DL11, another DL11-E, and at the bottom of
the list are a few MAINDECs DL11-E, DL11-C-D-E. I might have missed one.
- Henk, PA8PDP.

...
  -----Original Message-----
 From: cctalk-bounces at classiccmp.org 
 [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Jay West
 Sent: woensdag 29 maart 2006 6:27
 To: General Discussion: On-Topic and Off-Topic Posts
 Subject: Re: 11/45 RTC

 It was written....
  DL11-W prints and user manual are on bitsavers I
believe:

 http://www.bitsavers.org/pdf/dec/unibus/EK-DL11W-OP-001_May77.pdf
 http://www.bitsavers.org/pdf/dec/unibus/MP00106_DL11-W_Aug77.pdf  
 How did I miss that?? I've been all over that specific page 
 the past week :\

  Also, try running the DL11-W diagnostic from the
XXDPv2.5   disk. It is 
  ZDLDI0 (see diag hnbk p 2.34)

 It will tell you if your DL11-W interrupts are working or not.  I said many posts
ago... it fails with "bit 7 fails to set" 
 in reference to the test of the LTC (with regards to the 
 above diagnostic). Of course, without diagnostic source I 
 have no clue if the LTC test is before or after the full 
 serial port test, or maybe inbetween it... But that is as far 
 as it gets and the message I get.

 Jay West 

This message and attachment(s) are intended solely for the use of the addressee and may
contain information that is privileged, confidential or otherwise exempt from disclosure
under applicable law.  
If you are not the intended recipient or agent thereof responsible for delivering this
message to the intended recipient, you are hereby notified that any dissemination,
distribution, or copying of this communication is strictly prohibited.  
If you have received this communication in error, please notify the sender immediately by
telephone and with a "reply" message.  
Thank you for your cooperation.