--- jsalzman(a)hersheys.com wrote: If I recall, the two prong VIC-20 power supply is simply a 9VAC 1A power supply. You can get or fabricate a replacement from Radio Shack parts. If you are replacing an existing dead P/S, you have the connector(s) you need to connect to a 9VAC transformer. If not, the connector is similar to the old AC power cables which were used on the '80s portable cassette players/radios or Remington electric razors. --- end of quote --- I was able to make it work with an NES power supply (9VAC 1.3A), but anytime I tried to use the datasette, the screen would flicker and all operations would cease. I assumed this happened because the current was too low (high enough to drive the Vic, but not the Vic and the datasette). According to the 8-bit FAQ (in Mr. Dellett's post) this is probably correct -- the lowest-current one listed there uses 1.7 amps. Thank you for the response! -- MB ------------------------------------ "YOU! Out of the gene pool!" <raoulduke(a)dartmouth.edu> http://www.dartmouth.edu/~marionba